• Help: Saab repair in Valmiera?
Page 1 of 1

Re:Help: Saab repair in Valmiera?

Posted: Thu Feb 26, 2009 5:31 am
by vidvuds
will wrote:Hello, i´m from Estonia and have a small probelm with my car (Saab 9-5 Aero, 2002.a.) And now i am in Valmiera. Can somebody give information for repair places in Valmiera?
Whats is the problem?

In Valmiera there is no 24h workshop,

however tell me what is th eprob i will try to arrange a place for you tomorrow morning, counting that time when workshops and services start to work.

Re:Help: Saab repair in Valmiera?

Posted: Thu Feb 26, 2009 5:38 am
by vidvuds
I'll give you an answer tomorrow, however if you can still drive there are also places in CESIS, 30km from Valmiera. But let me check and get to you back till 11.00.

Re:Help: Saab repair in Valmiera?

Posted: Thu Feb 26, 2009 5:58 am
by vidvuds
will wrote:I´am now in Jekabpils. Thank you.
if Jekabpils, better make a bitt more km's and go to Riga, and check your car in either VIKINGI Gunara astras street 13, phone: +371 6 7149679 or ALfa motors, Ganibu Dambis 24a Mob. +371 29137890.


However there is probably a chance to ask ARNIJS from here, he could also help you. But then it is better than he would inform you about possible variants, I think he could help you!

Re:Help: Saab repair in Valmiera?

Posted: Thu Feb 26, 2009 6:14 am
by vidvuds
will wrote:I can´t go to Riga. I must go Cesis and Valmiera-there are the probelm.
If they in the Cesis have a TECH that would be good.
ok, i will try to find out if in valmiera or cesis is a palce where to attach your car to tech or something similar.

if your are not online, leave your cell phone so i can call you in some case.

Re:Help: Saab repair in Valmiera?

Posted: Thu Feb 26, 2009 6:25 am
by Arnijs
will wrote:I can´t go to Riga. I must go Cesis and Valmiera-there are the probelm.
If they in the Cesis have a TECH that would be good.
Workshops in CESIS don`t have TECH with SAAB memory card. Only RIGA workshops have it. If gearbox works normally, don`t worry. Warning light switching on possibly could be one of the two speed sensors` fault. But fault codes read and cleared by any diagnostic equipment, supporting OBD2 protocol (with can-bus lines support) It is not necessary to use TECH
P.S. Check oil level in gearbox is it OK. If yes, you can drive without worries.